System-Level Design:Interconnection Strategy

By -
Interconnection Strategy

Modules in a digital system are usually interconnected in some carefully architected, consistent manner. If point-to-point interconnections are used, they are used throughout the system, or in a subsystem. In the same manner, buses are not broken arbitrarily to insert point-to-point connections or rings. For this reason, digital system design programs usually assume an interconnection style and determine the system performance relative to that style. The most common interconnection styles are bus, point-to-point, and ring.

Comments

Post a Comment

Popular posts from this blog

Dynamic Random Access Memory:DRAM Memory Cell

By -
Image
DRAM Memory Cell In early CMOS DRAM storage cell design, three-transistor and four-transistor cells were used in 1-Kb and 4-Kb generations. Later, a particular one-transistor cell, as shown in Figure 55.4(a), became the industry standard [5,6]. The one-transistor (1T) cell achieves smaller cell size and low cost. The cell consists of an n-channel MOSFET and a storage capacitor C s. The charge is stored in the capacitor C s and the n-channel MOSFET functions as the access transistor. The gate of the n-channel MOSFET is connected to the word-line WL and its source/drain is connected to the bit-line. The bit-line has a capacity C BL , including the parasitic load of the connected circuits. The DRAM cell stores one bit of information as the charge on the cell storage capacitor C s. Typical values for the storage capacitor C s are 30 to 50 fF. When the cell stores “1”, the capacitor is charged to V DD – V t. When the stores “0”, the capacitor is discharged to 0 V. During the READ ...
Read more

CMOS/BiCMOS Technology:BiCMOS Technology.

By -
Image
BiCMOS Technology Development of BiCMOS technology began in the early 1980s. In general, bipolar devices are attractive because of their high speed, better gain, better driving capability, and low wide-band noise properties that allow high-quality analog performance. CMOS is particularly attractive for digital applications because of its low power and high packing density. Thus the combination would not only lead to the replacement and improvement of existing ICs but would also provide access to completely new circuits. Figure 2.25 shows a typical BiCMOS structure [112]. Generally, BiCMOS has vertical npn bipolar junction transistor, lateral pnp transistor, and CMOS on the same chip. Furthermore, if additional mask steps are allowed, passive devices are integrated, as described in the previous section. The main feature of the BiCMOS structure is the existence of a buried layer because bipolar processes require an epitaxial layer grown on a heavily doped n+ subcollector to reduce co...
Read more

Switched-Capacitor Filters:Performance Limitations

By -
Image
Performance Limitations The arguments up to now described are valid assuming an ideal behavior of the devices in the SC network (i.e., opamp, switches, and capacitor). However, in the actual realization each of them presents nonidealities which reduce the performance accuracy of the complete SC circuit. The main limitations and their effects are described in the following. Finally, considerations about noise in SC systems conclude this section. Limitation Due to Switches As described before, CMOS switches satisfy both low on-resistance and zero voltage-drop requirements. However they introduce some performance limitations due to their intrinsic CMOS realization. The cross section of a NMOS switch in its on-state is shown in Figure 62.25. The connection between its nodes N1 and N2 is guaranteed by the presence of the channel, made up of the charge Q ch. The amount of charge Q ch can be written as where V i is the channel (input) voltage. Both nodes N1 and N2 are at voltage V ...
Read more